|
|
本帖最后由 hlhchina 于 2011-11-30 21:38 編輯 , W R1 J; ? l+ d# `# ?& B
2 B+ }+ B0 v) `1 @
我在做金屬切削仿真，在金屬切削仿真中采用自適應網格，但是在網格檢查時出現自適應不能使用單元畸變控制！！！) Q4 F" x* ~6 H
問題描述如下：
9 w% j, i3 t( T9 ?Adaptive meshing is not supported for elements used with the distortion control. $ }2 I& d4 k# X1 F! b. q% h. o8 u
Domain name: assembly_adapt
" u& L9 t4 z9 a- q4 I* v' V5 |Abaqus/Explicit Packager exited with an error - Please see the status file for possible error messages if the file exists.
5 B/ }4 s- o Z% f' Q e
M* x( ?: M7 w, R1 }+ V4 S" {但是不用網格畸變控制吧，又出現了網格畸變問題：
H; Q* {6 Z6 XThe elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.% E7 e4 b( A; O- M* r
The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.4 s0 f" a3 z6 V1 e; l* M$ W
Print-out suppressed for subsequent distorted elements
4 A5 g: h% w+ k% L) k& lThere are a total of 60 excessively distorted elements.
8 M1 u8 a7 }4 i請求各位達人幫助，萬分感謝！！！+ Z7 j& G+ e6 A2 S, _3 |
|
|
發表于 2011-11-30 20:51:21
